This week we were on our final task before starting to build the actual device. This was quite tricky because it told us what we had to create but no steps on how to do it. We had to use our general knowledge on how the nxt worked. We had to create something similar to pilot 4 but more of a challenge. In the end we managed to create it, this took us a few goes to complete, so unfortunately we didn't have time to start building the device. Next lesson we will be building the device.

We used ROBOLAB to switch off and on lamps and we learnt how to use the touch sensor. The sensor which opened my eyes was the light sensor because on the actual device itself it tells you how dark it is by percentage. 

On week 4 we carried on using ROBOLAB and got use to the different components which the NXT has to offer. Last week we had finished pilot 1& 2 so this week we are moving on to pilot 3 & 4. We used ROBOLAB to switch off and on lamps and we learnt how to use the touch sensor. The sensor which opened my eyes was the light sensor because on the actual device itself it tells you how dark it is by percentage. The picture on the right is an example of the different pilots we are doing

On Week 3 I started using ROBOLAB. This programme allowed me and my partner to move the sensors. The instructions helped us get used to the layout of the programme and that is where we started to be able to control the sensors such as: getting the motor running and putting how many seconds it should go on for. Then we started to programme the NXT, we started on pilot 1 & 2 and we quickly got that done.

Monday, 10th January, 2011:

Today we were looking at the NXT in more detail. By doing this we answered questions to make sure we know the basic functions of the device such as: knowing all the sensors and what they are used for. We also learned the outputs and inputs of the device like the sensors go along the bottom and the motors go along the top. Plus you can plug your USB for data, you can also use blue tooth to do this. The motors are used for moving the robot around, this is an extraordinary device as it tracks each piece of small data. Then by using the USB cable we were able to connect the NXT to the computer, after that we accessed a programme called "ROBOLAB".  Unfortunately we were out of time so we had to use "ROBOLAB" next lesson. This lesson was really good because i learnt a lot  more about the NXT.

Introduction

This week we have been starting on our "Robotics work". We were shown the parts of the machine. Plus we had a video explaining the different functions of the machine